BWFYM - INDUSTRIAL OIL R&O 68, CPS253006

Product Identification

Product ID:INDUSTRIAL OIL R&O 68, CPS253006
MSDS Date:10/07/1989
FSC:9150
NIIN:00N056398
MSDS Number: BWFYM

Responsible Party
CHEVRON ENVIRONMENTAL HEALTH CENTER INC
15299 SAN PABLO AVE.
RICHMOND, CA 94804
US

Emergency Phone: 800-457-2022

Info Phone: 800-582-3835

Cage: 0AHD1

Contractor
CHEVRON ENVIRONMENTAL HEALTH CENTER INC
4054 RICHMOND, CA 94804 US

Telephone: 800-582-3835

Cage: 0AHD1

Ingredients

MINERAL OIL, PETROLEUM DISTILLATES, HYDROTREATED (SEV),

CAS: 64742-54-7

RTECS: PY8035501

Fraction By Weight: >99%

OSHA PEL N/K

ACGIH TLV: N/K


ADDITIVES

Fraction By Weight: <1%

OSHA PEL N/K

ACGIH TLV: N/K

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:THE HAZARD EVALUATION IS BASED ON DATA
FROM SIMILAR MATERIALS. THIS SUBSTANCE IS NOT EXPECTED TO CAUSE
PROLONGED OR SIGNIFICANT EYE OR SKIN IRRITATION. THE SYSTEMIC
TOXICITY HAS NOT BEEN DETERMINED. H OWEVER, IT SHOULD BE
PRACTICALLY NON-TOXIC TO INTERNAL ORGANS IF IT GETS ON THE SKIN, IF
INHALED OR IF (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: SWALLOWED. THIS PRODUCT CONTAINS
PETROLEUM BASE OILS WHICH MAY BE REFINED BY VARIOUS PROCESSES
INCLUDING SEVERE SOLVENT EXTRACTION, SEVERE HYDROCRACKING OR SEVERE
HYDROTREATING.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:INHAL: REMOVE TO FRESH AIR. SUPPORT BRTHG (GIVE OXYGEN/ARTF
RESP) . EYES: FLUSH W/FRESH WATER FOR AT LEAST 15 MIN. REMOVE
CONTACT LENSES IF WORN. SKIN: WASH SKIN THORO W/SOAP & WATER.
REMOVE & W ASH CONTAMD CLTHG. INGEST: GIVE WATER/MILK TO DRINK &
TELEPHONE FOR MED ADVICE. CONSULT MED PERS BEFORE INDUCING VOMIT.
IF MED ADVICE CANNOT BE OBTAINED, TAKE PERSON & PROD CNTNR TO
NEAREST (SUPDAT)

Fire Fighting

Flash Point Method:COC
Flash Point:>410F,>210C
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM, WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT . READ THE ENTIRE DOCUMENT AND LABEL BEFORE
USING THIS PRODUCT.
Unusual Fire/Explosion Hazard:NONE SPECIFIED BY MANUFACTURER.

Accidental Release

Spill Release Procedures:STOP SOURCE OF LEAK/RELS. CLEAN UP RELS AS
SOON AS POSS. CNTN LIQ TO PVNT FURTHER CONTAM OF SOIL, SURF
WATER/GROUNDWATER. CLEAN UP SM SPILLS USING APPROP TECHNIQUES SUCH
AS SORBENT MATLS/PUMPING. WHER E FEASIBLE & APPROP, REMOVE CONTAMD
SOIL. (SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:DO NOT WELD, HEAT/DRILL CNTNR. RESIDUE
MAY IGNITE W/EXPLO VIOLENCE IF HEATED SUFFICIENTLY. CAUTION! DO NOT
USE PRESS TO EMPTY DRUM OR EXPLO MAY RSLT.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Exposure Controls

Respiratory Protection:NO SPECIAL RESPIRATORY PROTECTION IS NORMALLY
REQUIRED. HOWEVER, IF OPERATING CONDITIONS CREATE HIGH AIRBORNE
CONCENTRATIONS, THE USE OF A NIOSH/MSHA APPROVED RESPIRATOR IS
RECOMMENDED.
Ventilation:USE ADEQUATE VENTILATION TO KEEP THE AIRBORNE
CONCENTRATIONS OF THIS MATERIAL BELOW THE RECOMMENDED EXPOSURE
STANDARD.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:AVOID PRLNG OR FREQUENTLY RPTD SKIN CONTACT
W/THIS MATL. SKIN CONTACT CAN BE MINIMIZED BY WEARING PROTECTIVE
CLOTHING.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
HAZ DECOMP PRODS: CAN PRODUCE CARBON MONOXIDE. FIRST AID PROC: MED EMER
TREATMENT CENTER/HOSPITAL. SPILL PROC: FOLLOW PRESCRIBED PROCEDURES
FOR REPORTING & RESPONDING TO LARGER RELEASES. THIS MATL IS NOT
EXPECTED TO PRESENT ANY ENVIRON PROBLEMS OTHER THAN THOSE ASSOC
W/OIL SPILLS.

Chemical Properties

Spec Gravity:0.88 @ 15.6C
Solubility in Water:INSOLUBLE
Appearance and Odor:CLEAR, COLORLESS LIQUID.

Stability

Stability Indicator/Materials to Avoid:YES
MAY REACT WITH STRONG OXIDIZING AGENTS, SUCH AS CHLORATES, NITRATES,
PEROXIDES, ETC.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NORM COMBUST FORMS CARBON DIOXIDE &
WATER VAP; INCOMPLETE COMBUST CAN PRDCE CARBON MONOXIDE. INCOMPLETE
COMBUST (SUPDAT)

Disposal

Waste Disposal Methods:PLACE CONTAMINATED MATERIALS IN DISPOSABLE
CONTAINERS & DISPOSE OF IN A MANNER CONSISTENT WITH APPLICABLE
REGULATIONS. CONTACT LOCAL ENVIRONMENTAL OR HEALTH AUTHORITIES FOR
APPROVED DISPOSAL OF THIS M ATERIAL.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.